Clap to Find Phone & Whistle

Lost your phone under a pillow or in a bag again? Clap or whistle and it rings, flashes and vibrates so you can follow the sound. When you step away from your desk, switch to the don't-touch alarm and anyone who picks your phone up sets off a loud siren. FIND IT WITH A CLAP OR A WHISTLE Arm the app, keep it open, and leave the phone nearby. When you can't see it, clap or whistle. The phone plays a loud alarm with SOS flashlight blinks and vibration, even in silent mode. Tap STOP to end it. • Trigger on clap, whistle or both • 8 alarm tones included, 2 extra tones unlock after a short rewarded ad • Sensitivity slider plus Desk, Pocket and Drawer/Bag presets • Double-clap confirm for noisy homes: it waits for two claps about half a second apart, so single knocks, TV sound and applause are much less likely to set it off • Room check right after arming, so a loud room does not set it off by itself • Set It Down countdown that arms the app for you after 10 seconds to 3 minutes DON'T TOUCH MY PHONE Put the phone on a table, switch to Motion and arm it. After a 5-second settle, lifting or bumping the phone starts the siren and flash. • Motion log with the time and type of every disturbance • Intruder photo: the front camera takes one quiet picture when the alarm fires. Only the last 5 are kept, on this device only YOUR DATA STAYS ON YOUR PHONE The microphone and motion sensor are processed on the device and nothing is uploaded. While armed, the phone keeps a temporary audio file only to measure loudness. The app never plays or shares it and deletes it when listening stops. PLEASE NOTE This app rings a phone that is close to you. It is not a GPS tracker and cannot find a phone that is in another place. Detection works while the app is open on screen. Arm it now, take a few steps back and clap once to hear how it sounds in your room.

The first-run guide scrolls from the top, with its start button below the title and above the banner. Arming permission prompts for camera, microphone or motion return without a full-screen ad. A pending ad after alarm stop or sound/motion switch is dropped on any touch, arm/disarm, alarm test, Back or leaving. Frequency limits and nearby-phone detection stay the same.