Magnetometer: Stud Finder

Magnetometer is a metal detector and stud finder that uses your phone's built-in magnetic sensor to find iron and steel behind walls, under floors and inside furniture, and to measure the magnetic field in µT, mT or Gauss. ★ What it detects Ferrous metal only: screws and nails in studs and joists, steel pipes, rebar, brackets, hinges and door strikes, within a few centimetres of the phone. Sweep slowly with the phone against the surface. ★ What it cannot detect Gold, silver, copper, aluminium, wood and plastic are not magnetic, so no phone sensor can find them. It is not a coin finder and it does not trace copper wiring. ★ Calibrates as you turn the phone The phone's own magnets create a large offset in the sensor. The app learns it while you turn the phone, so tilting alone does not look like metal. A progress bar on the meter shows the calibration; when it is full the reading goes live and the phone gives a short vibration. Zero here starts it again at any spot. ★ Meter modes • Auto: radial gauge of the field deviation • Earth Field: total field with a latitude band • Metal Detector: deviation with an intensity verdict and optional vibration pulses that speed up near metal ★ Scanner and Stud Finder Slide the phone flat along a wall: the Stud Finder marks the strongest point, where the screws and nails that hold the board to the stud are. The metal scanner shows the live deviation while you sweep. ★ Compass Magnetic north or true north with declination. ★ Data and history • Live X / Y / Z chart, min, average, max and peak • Sensitivity 0.5x to 2.0x • Saved readings with 7-day trend, favourites and side-by-side comparison • One-second continuous log with CSV export • Share a reading as an image, optional GPS tag • Statistics report unlocked for 24 hours with a short rewarded ad For DIY and renovation, checking for rebar and pipes before you drill, and physics experiments with magnets.

Magnetometer+ adds a Ready-check to Stud Finder that tunes the mark to this phone in under 30 seconds, and the app now runs on a newer, shared foundation. Coming back from sharing a result or a permission prompt no longer brings up an ad, and full-screen ad spacing now holds when you close and reopen the app. Your saved measurements, calibration and settings are untouched.